Your Cart   VIEW

Pulse Charger (Video Intro)

Posted on: October 10th, 2014 by Pulse

Scooters are a safe and cost-effective way for kids to stay active. They also involve minimal upkeep to keep them running smoothly. These videos will show owners of the Pulse Charger how to assemble their scooter and also how to perform any replacements. These videos are easy to follow and provide step-by-step walk through that are simple and easy to implement.

scooter

Pulse Charger – Throttle Replacement

To replace the throttle you will first need to unscrew the deck with a Phillips screwdriver to get to the battery box. Then you can proceed to finish the throttle replacement with the wrenches and screwdriver and screw the deck back on.

Pulse Charger – Stem Tube Assembly

Stem tuber assembly is extremely simple. All you have to do is slide the stem tube down until it pops into place and then secure the hardware with wrenches.

Pulse Charger – Rear Wheel Replacement

First you will need to remove the side cover bolts with a hex wrench to loosen the side covers. After removing the side covers you can then proceed to remove the old wheel and assemble the scooter with the new one.

Pulse Charger – Motor Replacement

Motor replacement has more steps than most of the other demos so watch this video carefully. To replace the motor first you will need to remove the deck, and the batteries will also need to be removed before replacing the motor and reassembling

Pulse Charger – Handlebar Assembly

Assembling a handlebar is an extremely simple procedure. Simply watch this video to see how quickly you can install a handlebar with the clamp, before securing the hardware with wrenches.

Pulse Charger – Front Wheel Replacement

Front wheel replacement is easy to perform. First remove the old wheel with wrenches, and then reinstall the new wheel and axle hardware.

Pulse Charger – Brake Adjustment

This video demos how you can turn the brake cable adjuster barrel. You can turn it clockwise to loosen or counterclockwise to tighten.

Pulse Charger – Belt Replacement

Belt replacement involves numerous small steps so watch this video carefully before proceeding. You will need a Phillips screwdriver and various wrenches to perform the belt replacement properly.

Pulse Charger – Battery Replacement

You will need a Phillips screwdriver to unscrew the deck so that you can gain access to the battery box. Then you will need to remove the old batteries before installing the new batteries and screwing the deck back in.

Pulse Charger – Battery Charging

Incredibly easy, battery charging is important but simple to do. Simply use the charger to recharge the scooter battery fully before using it again.

photo credit: g3Tography via photopin cc

Comments are closed.